top of page
NAVY LEAGUE CADET CORPS 193 CODIAC MONCTON NEW BRUNSWICK

CTS 04 - 1.4 Basic Drill at the Halt - To the Front Salute, Remove/Replace Headdress, Dismiss Lesson Plan
Duration:
1 Period (45 Minutes)
WHAT TEACHING METHOD IS SUITABLE FOR THIS PERIOD:
The approach should be using the Presentation and Practical Activity methods.
WHAT MATERIAL DO I NEED?:
1. Parade deck
2. NL (225) NLC Drill Manual
INTRODUCTION:
What - Cadets will learn (a) the salute to the front, (b) the remove headdress, (c) the replace headdress, and (d) the dismiss.
Why - Learning these movements is essential for a division mustered on the deck. These movements will be used on a frequent basis.
Expectations - The cadet is required to perform the movements as part of the corps’ nightly routine.
TEACHING POINTS:
The Standard Pause – Used to ensure that all members of a division use the same timing when a movement has more than one-step. Timing between movements is counted by using a standard pause. If every movement is counted as a “ONE”, then the time between movements is counted as “TWO…THREE”. Numbers should be called out in sequence every ½ second.
The salute is given with the right hand. When physical incapacity or carrying of articles makes a salute with the right hand impracticable, compliments will be paid by turning the head and eyes to the left or right or standing to attention.
***Are there any questions?***
SALUTING TO THE FRONT
Purpose – the movement is used when:
-
The salute is given with the right hand
-
Before and after speaking with an officer;
-
When the Canadian Flag is being raised or lowered (Colours and Sunset); and
-
During the playing of the National Anthem.
On the command TO THE FRONT SALUTE BY NUMBERS, SQUAD – ONE, squad members shall:
a. bend the right elbow and open the palm of the right hand as it passes the shoulder; and
b. force the right hand by its shortest route to the front of the headdress so that:
(1) the palm of the hand is facing down,
(2) the thumb and fingers are fully extended and close together,
(3) the tip of the second finger is in line with the outside of the right eyebrow and touching the outside edge of the headdress or arm of glasses, if worn,
(4) the hand, wrist and forearm are in a straight line and at a 45-degree angle to the upper arm,
(5) the elbow is in line with the shoulders, and
(6) the upper arm is parallel to the ground.
On the command SQUAD – TWO, the hand is brought sharply to the position of attention by the shortest route, without slapping the thigh. The hand is closed after the forearm is lowered below shoulder level.
On the command TO THE FRONT – SALUTE, the two movements are combined. The standard pause shall be observed between movements.
***Are there any questions?***
SALUTING TO THE RIGHT OR LEFT
Purpose – the movement is used when:
-
Passing an officer;
On the command TO THE RIGHT (LEFT) SALUTE BY NUMBERS, SQUAD – ONE, saluting shall be executed as detailed above except that:
a. the head and eyes shall be turned smartly to the right (left) as far as possible without straining;
b. when saluting to the left, the right hand, wrist and arm are brought further over to the left to the correct position in line with the outside edge of the right eyebrow; and
c. when saluting to the right, the arm is moved to the rear, with the tip of the second finger remaining in line with the outside edge of the right eyebrow.
On the command SQUAD – TWO, the hand is brought sharply to the position of attention, and simultaneously the head and eyes are turned smartly to the front.
On the command TO THE RIGHT (LEFT) – SALUTE, the two movements are combined. The standard pause shall be observed between movements.
When wearing headdress other than a cap with a peak or white top, the second finger is 2 cm above and in line with the outer tip of the right eyebrow.
***Are there any questions?***
REMOVE HEADDRESS
Purpose – used for prayers; during the consecration of colours; whenever it is desirable to honour a dignitary by giving three cheers.
When ordered, all ranks on parade shall remove their headdress with the exception of:
a. adherents of faiths for whom this is not permitted or acceptable (e.g., Sikhs);
b. musicians when on parade with instruments;
c. when ordered in connection with a religious event, it is optional for members to remove or retain his or her headdress in accordance with his or her belief.
On the command REMOVE HEADDRESS BY NUMBERS SQUAD – ONE, squad members shall bring the right hand to the front of the headdress by the shortest route and grasp it in the front between the thumb and fingers, with the fingers aligned and parallel to the shoulders as much as practicable.
On the command SQUAD – TWO, squad members shall maintain the bend in the right arm, cut the upper arm to the right side of the body and the forearm parallel to the ground, and bring the right hand to the centre of the body. Maintaining the grasp on the peak of the headdress, squad members shall hold the headdress above the hand and in the centre of the chest.
On the command REMOVE – HEADDRESS, the two movements are combined. The standard pause shall be observed between the movements.
***Are there any questions?***
NOTES:
i) Standing at Ease with headdress removed – same as “Stand at Ease” except that the hands and cap remain in the same position as above;
ii) Standing Easy with headdress removed – cut the right arm (with cap) to the right side of the body, maintaining the same grip and ensuring that the right arm is straight.
iii) When at the “Stand Easy” position, cadets should immediately revert to the “Stand at Ease” at the beginning of the next order; and
iv) Stand at Ease to Attention with headdress removed – same as “Attention” except that the hands and cap remain in the same position.
***Are there any questions?***
REPLACE HEADDRESS
Purpose - used to bring cadets to the proper position of Attention after headdress has been removed.
Au commandement « DÉCOUVREZ — VOUS », les deux mouvements sont combinés. Il faut observer la pause réglementaire entre les deux mouvements.
On the command SQUAD – TWO, resume the position of attention by cutting the right arm or arms to the side.
On the command REPLACE – HEADDRESS, the two movements are combined. The standard pause shall be observed between movements.
Once the headdress has been adjusted, the hand/hands remain at the head with the elbows towards to the body. Once ATTEN-TION is given, cut the arm/arms to the side (position of attention).
***Are there any questions?***
DISMISSING A SQUAD
Purpose - to let the cadets in a division carry on in a uniformed manner
The command DIS – MISS signifies the end of a parade, period of instruction, etc. The squad shall be in line and at attention when dismissed.
On the command DIS – MISS, squad members shall:
a. turn right;
b. observe the standard pause;
c. salute, if an officer is on parade;
d. observe the standard pause; and
e. march off independently, in quick time, from the place of parade.
***Are there any questions?***
CONCLUSION:
These positions and movements that form the basis for all other movements. Timing is important, but will seem easier as you practice each movement. Remember that all of these positions are designed with comfort in mind, so if it doesn’t feel right, ask an instructor for assistance.
TESTING:
Cadets are expected to perform drill during each training night. Before a cadet is promoted to New Entry, they will have to demonstrate the ability to perform each one of these movements, either during a muster or during a scheduled evaluation period.
bottom of page